Silicone Flat Half Gasket for 2" Tri Clover Compatible Cap

These gaskets work very well. They do not require you to clamp down very hard on the triclover to get a good seal on the sanke keg. There doesn't appear to be a picture of them on the site at the time of writing this, but they are much wider than the standard o-ring that came with the original sanke keg fermentor kit. They extend out to the edge of the triclover fitting, which allows you to see that it is properly aligned between the keg opening and the triclover fitting. My advice would be to pick up a couple of them on your next order because you're not going to find these anywhere else.